Kick Plates On Fire Rated Doors

A 1 1 see annex k for general information about fire doors.

Kick plates on fire rated doors. A protection plate may be a kick plate stretcher plate or armor plate installed to protect the face of the door from damage due to traffic and abuse. Many door manufacturers have tested with non labeled plates up to 48 inches 1219 mm high with no special requirements but nfpa 80 currently requires a field. Find door kick plates at lowe s today. Nfpa 80 allows non labeled kick plates to be field installed on fire doors as long as the top of the kick plate is not more than 406 mm 16 in above the bottom of the door.

Plates over 16 in height may affect the fire protection but are allowed as long as they have been tested and approved. Kick plate is ideal for commercial doors adding a decorative accent and protecting the door surface in high traffic areas. Kick the everbilt 10 in. Door protection for rated doors.

Protective plates are usually flat sheets of metal or plastic applied to one or both sides of door faces and located in the lower 16 of the door. Nfpa 80 defines a door protection plate as protective material applied to the face of a door and generally made of approximately 0 05 in. Yes steelcraft doors we are approved up to 48 in height or not to exceed a total 2304 square inches per face. Nfpa 80 allows non labeled kick plates to be field installed on fire doors as long as the top of the kick plate is not more than 16 inches 406 mm above the bottom of the door.

Easily cleaned for a clean look. 1 1 1 with the exception of fabric fire safety curtain assemblies this standard addresses assemblies that have. Factory installed protection plates shall be installed in accordance with the listing of the door. Yes a filler plate can be used to cover an ept prep as long as it is made from the same material as the frame.

This standard regulates the installation and maintenance of assemblies and devices used to protect openings in walls floors and ceilings against the spread of fire and smoke within into or out of buildings. The 8402 kick plate is a label for metal doors and b for wood doors. When class starts the teacher. The everbilt 10 in.

Standard for fire doors and other opening protectives indicates that protection plates can be applied to the bottom 16 of a door panel one or both sides. Screw mounting for steel fire doors rated up to and including 3 hours and wood composite type fire doors rated up to 1 1 2 hours. 1 2 mm thick brass bronze aluminum or stainless. My issue is that on a fire rated door our product is only used for the 5 7 minutes while the kids are coming into the classroom building.